Overview |
Why 23 gauge? |
Why Grex? |
Features |
Specs |
23 Ga. Pins |
Gallery |
Videos |
Guide |
Media |
Support |
01. What's the difference between all the models? 02. What is the Auto Lock-out feature? 03. Why is the minimum pin length for the P650L different from the P650? 04. Can slight headed pins be used in my Grex pinners? 05. Can I use other brands of pins in my Grex pinners? 06. Where can I purchase pins for my Grex pinner? 07. Why can't I use 1-1/4" (32mm) pins with my Grex pinner? 08. Where are Grex pinners made? 09. What comes with each Grex pinner? 10. Can I fit a No-Mar tip on to a P630? 11. Is there a difference between the No-mar tip on the P635 and P650? 12. Do I need to lubricate my Grex pinner? 13. What pin lengths can my Grex pinners drive? 14. Where do I purchase a Grex pinner? 15. How much pressure do I need to operate the Grex pinners? 16. Want kind of a compressor is needed for my Grex pinner? 17. Which Grex pinner should I choose? 18. Can I drive 23 gauge headless pins into hardwoods? 19. Will the 23 gauge pins drive in straight? 20. What is the warranty of a Grex pinner? 21. Are there replacement parts available for my Grex pinners? 22. Where can I get my Grex pinner repaired? 23. Why aren't pins setting into the wood? 24. Can my Grex pinner be used on steel studs? 25. How do I adjust the depth of drive of my Grex pinner? Due to the kind of work folks use pinners for, a depth of drive knob is not practical. Your Grex pinner arrives from the factory with a set depth of about 10 to 20 thousandths of an inch. This depth is primarily a function of the distance to which the driver blade extends out of the pinner when shooting. Depending on the hardness of your workpiece, a greater depth of set may be possible by increasing the operating air pressure.
If you wish for an even greater depth of set, you can do the following. DISCLAIMER. This modification is irreversible and if done improperly may result in tool damage. Proceed with caution and only attempt if you are highly experienced with pneumatic nailer operation and maintenance.
Using a file, NOT A GRINDER, take a couple of passes over the tip of the pinner nose, from side to side, not front to back. Then try to take a shot into a piece of scrap. If this depth is suitable, you are done, if not, repeat. Do not take so much off the tip of the tool that the driver blade comes out by more than 1/32 of an inch. This modification may potentially compromise the longevity of your driver.
26. Why are Grex pinners the best pinners?
|